Burning Behaviour of Bunched Cables

EN 50399

The EN 50399 was based on IEC 60332-3 with the addition of heat release measurement and a modified air inlet system. This is accomplished by fitting a small instrumented section of ducting into the exhaust system of the rig and using this with associated FTT gas analysis instrumentation and software. The duct section houses all gas sampling probes, temperature and mass flow probes and has ports for the smoke measuring system.

The gas analysis instrumentation is housed in a 19" instrument rack containing:

  • Oxygen Analyser (paramagnetic) supplied with temperature and pressure compensation for primary heat release measurement
  • Carbon Dioxide Analyser (infrared) for use in heat release measurement
  • Dual stage soot filter, refrigerant cold trap, drying column, pump and waste regulators for conditioning the sample gases prior to analysis
  • Controls for the smoke measurement system (if purchased)
  • Data logger (if purchased)

Clients already owning the FTT Dual Cone Calorimeter, ISO 9705 Room/Corner test or SBI can use their cone instrumentation to measure heat release rate from their IEC 60332-3. Alternatively the EN 50399 Gas Analysis rack can be used to instrument other calorimeters (e.g. FTT Dual Cone Calorimeter etc.).

Burning Behaviour of Bunched Cables

IEC 60332-3

The European Commission and The European Cable Industry (EUROPACABLE) are finalising Classification criteria for evaluating electric cables throughout Europe under the Construction Products Directive (CPD). The Classification utilises the results obtained from traditional IEC 60332-3 test equipment fitted with heat and smoke release measurement instrumentation. The former is calculated by continuous measurement of the oxygen consumed and carbon dioxide generated in the combustion process. The basis of the new test protocol was developed by FTT’s Andrew Green with colleagues from SP (Sweden), ISSeP (Belgium), CESI (Italy) and Interscience (UK) as part of an EC funded FIPEC project. This project was managed by FTT director Stephen Grayson.

Modifying Existing IEC 60332-3 Apparatus To Measure Heat Release
Conversion of existing IEC 60332-3 apparatus to measure heat release is accomplished by fitting a small instrumented section of ducting into the exhaust system of the rig and using this with associated FTT gas analysis instrumentation and software and a modified test protocol. The duct section houses all gas sampling probes, temperature and mass flow probes needed, and the smoke measuring system.

Gas Analysis Instrumentation
These are housed in a 19" instrument rack containing:

  • Oxygen Analyser (paramagnetic) supplied with temperature and pressure compensation for primary heat release measurement
  • Carbon Dioxide Analyser (infrared) for use in heat release measurement
  • Dual stage soot filter, refrigerant cold trap, drying column, pump and waste regulators for conditioning the sample gases prior to analysis
  • Controls for the smoke measurement system (if purchased)
  • Data logger (if purchased)

Clients already owning the FTT Dual Cone Calorimeter, ISO 9705 Room Corner test or SBI can use their existing instrumentation to measure heat release rate from their IEC 60332-3. Alternatively the IEC Gas Analysis rack can be used to instrument other calorimeters (e.g. FTT Dual Cone Calorimeter etc.).

Smoke Measurement Systems
FTT can supply either laser or white light systems for smoke measurement in compliance with the standard. The laser system is similar to that used in the cone calorimeter and complies with ISO 5660 incorporating an advanced noise reduction specification. The white light system is similar to that used in the SBI test and constructed to DIN 50055.

Fire Testing Technology

Unit 19, Charlwoods Road, East Grinstead,
West Sussex, RH19 2HL, UK.

Tel.: +44.(0)1342.323600
Fax: +44.(0)1342.323608
Email: sales@fire-testing.com

Company Reg. No. 2387681
VAT Reg. No. 528.0253.63

Scroll to Top